This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Second Internet Connection

Ok, so my company is running Citrix over a very congested internet connection.  Instead of upgrading everything to a T1+, I have a DSL connection that I must dedicate to Citrix.

I am new to Astaro so I don't think I've grasped it yet and I need help.

ASG has two NICs.  1 is a single port, the other a 2 port.

Nic #1 has my Interal Network.

Nic #2 - Port 1 is my primary internet connection and is set as the default GW.  There are additional IP addresses on this interface. Citrix currently works with it's old IP.  Port 2 is the new DSL connection.  I have activated the interface and assigned its static IP.  An additional address interface has been created for Citirx and it has it's own new static IP.  I would like Citrix to also come through this interface/IP and I can see traffic coming in when I try to hit it through Citrix using the new IP...but the packets are dropped.

What's my fix?  I have tried, Any to Citrix-Service to Internal Citrix IP.  I've tried Internal Citrix IP to Citrix-Service to Any IP, and still no luck

What am I doing wrong?  Does it have something to do with the gateway?  Once I get Inbound traffic working, how is Citrix on the new IP going outbound?

I thought about doing Uplinking + Multipathing, but don't think I'd be able to figure it out without breaking everything.

Sorry if it's a simple fix.  Thanks in advance, I appreciate all help.


This thread was automatically locked due to age.
  • Ok, I think I'm starting to see where this isn't working...I didn't setup anything in the NAT.

    Can anyone help me pull this all together.  Long day, and the screen is starting to spin.
  • Update:

    I was able to get the packets to come in without being dropped, however, Citrix still did not work for me over port 1494 using the new IP.  I believe that just has something to do with Citrix.  However, I am concerned that the packets can come in, but aren't going out through the correct gateway.

    How can I test this?

    I.E.

    Internet connection #1 is x.x.65.125 and is the default gateway.
    Internet connection #2 is x.x.23.135 and has a gateway set, and the new IP for Citrix is .23.130.  I can see the packets coming in on .130 but that's about it.

    How do I make sure the traffic is coming out of .135 or .130.

    Any help would be very much appreciated.

    Thank you!
  • Which solution are you using - multipath rules or SNAT with a policy route?

    Cheers - Bob