This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Weird problems after upgrading from 7.202

A lot of my NAT rules will not enable and I cannot do an ANY ANY or a group of Services now for some reason. Any ideas?

I need this fixed ASAP as some are quite important.

One of the values you entered is syntactically or logically incorrect.

It's happening to my DNAT and SNAT rules, it's odd because half of them ARE working and I can't disable them without the same message as well.

This thread was automatically locked due to age.

Parents

0 JustinLEdwards over 16 years ago

I deleted the second Any, and it seems to be working. Is that not needed? I haven't had a problem with it until now.
Cancel
Vote Up 0 Vote Down

Cancel
0 JustinLEdwards over 16 years ago in reply to JustinLEdwards

Also if that is the correct way without the second ANY, what is the use of that field?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 JustinLEdwards over 16 years ago in reply to JustinLEdwards

Also if that is the correct way without the second ANY, what is the use of that field?
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 BAlfson over 16 years ago in reply to JustinLEdwards

It's for when you want to change the service, instead of or in addition to the address.
Cancel
Vote Up 0 Vote Down

Cancel
0 JustinLEdwards over 16 years ago in reply to BAlfson

Thank you :-)
Cancel
Vote Up 0 Vote Down

Cancel