This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SSLVPN through Astaro

Hello Folks!
I have just setup an Astaro home version for testing and have a couple of questions.

I use a Juniper SSL VPN for work and am having some problems with getting it to connect. I added rules for allowing TCP port 443 (probably didn't need to) and UDP port 4500. I tried watching the logs, but did not see any denial of traffic based on my IP address or those ports. Any help would be greatly appreciated!

Scott

This thread was automatically locked due to age.

0 BarryG over 16 years ago

Are you using the HTTP proxy on Astaro?

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 sdamron over 16 years ago in reply to BarryG

Are you using the HTTP proxy on Astaro?

Barry

I have tried it with the proxy on as well as off. I even did a reboot after turning it off, because it was acting very odd. I have a Juniper Netscreen 208 that I am running out of maintenance on running currently on another WAN line, and it works just fine. I am used to doing zone based security on firewalls, so it is not a reach to configure the Astaro, but this is the one thing holding it up right now.
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 16 years ago in reply to sdamron

Have you setup Masquerading (if needed)?

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 sdamron over 16 years ago in reply to BarryG

Have you setup Masquerading (if needed)?

Barry

Yep, everything is NAT'd to my WAN interface address.
Cancel
Vote Up 0 Vote Down

Cancel
0 sdamron over 16 years ago in reply to BarryG

Have you setup Masquerading (if needed)?

Barry

I figured out the problem. I had to uninstall the network connect software from Juniper and re-install. Once I did this, it worked just fine.
Cancel
Vote Up 0 Vote Down

Cancel