This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot dissolve bridge

7.303

I have bridge setup over two NICs and one Internal interface assigned to br0.

I am at the point where I want to dissolve the bridge and create an external and internal interface to manage traffic....

When I click Disable Bridge, and Confirm Bridge Removal, I get the following message:

"One of the values you entered is syntactically or logically incorrect."

There's nothing I can do at this point - I'm stuck.

This thread was automatically locked due to age.

Parents

0 wwwiesel over 16 years ago

Hi!

is the object in use? If not hmm it seems like the object is broken. Try to create an backup and do a factoryreset or try some old backupfiles.

Hope this helps.
Cancel
Vote Up 0 Vote Down

Cancel
0 dspender over 16 years ago in reply to wwwiesel

I tried building a new box and restoring a backup. SAME error message.

I guess I just have trash my production system and start over... I'm paying for support but no one will respond to my emails and calls.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 dspender over 16 years ago in reply to wwwiesel

I tried building a new box and restoring a backup. SAME error message.

I guess I just have trash my production system and start over... I'm paying for support but no one will respond to my emails and calls.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Casual over 16 years ago in reply to dspender

I have had this problem, I disabled NAT and routing before turning off the bridg.
Cancel
Vote Up 0 Vote Down

Cancel