Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 2 subscribers
  • Views 644 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

QOS not working with HTTP Proxy enabled

derTobi
Hi,

i have setup QOS to limit bandwith to several Webservers like YouTube on a ASG 7.2. 

Simple QOS Rule: ANY -> ANY -> You Tube Servers (Group of IP addresses).
Limit works fine as long as i disable the HTTP Proxy.

When i enable the proxy (it doesn't matter which mode - transparent or not) QOS will be ignored.

I've tried several things in the QOS settings with source / destination / service settings without success.

Has anyone a working QOS limit for HTTP Traffic with proxy enabled?

Thanks a lot!

Tobi


This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to Dave Cooper
    I have it working with transparent proxy enabled. Don't use http port in your QoS rule. Use http proxy port in definition....

    Try to do the following:

    Look for the KB article "qos with http". Changes has only to be done in the definition of the service "HTTP Incoming".

    Change the name to e.g. "HTTP Proxy Incoming Packets", und use the following parameters: Type = TCP, Destination Port: 1:65535, Sourceport: "Port of HTTP Proxy" (Menu "Websecurity - HTTP - Advanced -  HTTP Proxy Port")

    I hope it will help you.

    Regards,

    Pretender