This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SDSL and PPPoE / policy based routing

redhorse2017 over 17 years ago

Hello!

We've got two external Interfaces, one SDSL with static IP-Adress, one PPPoE with dynamic IP-Adress. We use the SDSL-Line as a default gateway for HTTP-Traffic and VPN-Tunneling. The PPPoE-Interface should be used for one special Application (RDP) via VPN. So far, this is no problem, policy-based routing allows to use the PPPoE-Interface for RDP-Connections to this special IP-Adress. If the PPPoE-Connection is temporary not established, the ASG uses automaticly the default gateway (SDSL) instead of PPPoE. But after reestablishing the PPPoE-Connection ASG doesn't fall back to it, so the policy route doesn't work anymore. Does anyone has experiences with that kind of configuration?

Kind regards,
Christian

This thread was automatically locked due to age.

0 Schroeder over 17 years ago

Do you have an Interface or a Gateway route in your policy routing setup?
If you have a gateway route, try to switch to an interface route.

Greets

Schroeder
Cancel
Vote Up 0 Vote Down

Cancel
0 redhorse2017 over 17 years ago in reply to Schroeder

I use interface routing because of dynamic IP-Configuration the gateway is not known. The problem still exists, unfortunenatly.
Cancel
Vote Up 0 Vote Down

Cancel