This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Load balancing

I have two 10mb circuits one is for the users and the other is for our portal, I would like to have each circuit go to a ASG 425 and then connect the two ASG's together for load balancing. How can I accomplish this?

-J

This thread was automatically locked due to age.

Parents

0 RFCat_vk_01 over 17 years ago

Hi,
I assume you are trying to load balance across the CPUs. I would suspect you would need to put them in a cluster. I haven't done it and can only recommend you read the manual.

Ian M
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 RFCat_vk_01 over 17 years ago

Hi,
I assume you are trying to load balance across the CPUs. I would suspect you would need to put them in a cluster. I haven't done it and can only recommend you read the manual.

Ian M
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 James Shakour over 17 years ago in reply to RFCat_vk_01

the manual talks about load balancing between servers.

-J
Cancel
Vote Up 0 Vote Down

Cancel
0 RFCat_vk_01 over 17 years ago in reply to James Shakour

Hi,
there is a long section on load balancing, it isn't called load balancing but is part of the HA section.
I would have thought the load balancing and clustering would have their own headings.

Not sure what you mean by server
1/. is that web servers
or
2/. ASGs

Ian M
Cancel
Vote Up 0 Vote Down

Cancel