This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

webmail help....

I am trying to setup webmail through the ASG V7.

I have setup the interface under the additional addresses tab

I have setup the DNAT and the Packet Filter. (I followed the directions in the Astaro knowledgebase Scenario 3 - Additional public address)

whenever I try to use the outside address I used for webmail, it goes nowhere, if I throw a :4444 at the end i get to the WebAdmin page of the gateway.

What am I doing wrong?

Thanks in advance!

-J

This thread was automatically locked due to age.

0 mtaufik@inovasi.co.id over 17 years ago

Have you take a look packet filter's log?

otherwise, you can use Generic Proxy.
You can determine on Network Security - Advanced
Create the service definition (port) if the service is available
then select the webmail server for destination. For allowed Network you can specify or just choose any.

[:)]
Cancel
Vote Up 0 Vote Down

Cancel