Hi
I can't seem to get my SNAT translation to work properly. I have the following setup.
Source
10.1.1.* -> ASG->(VPN)192.168.112.*->Webserver (.100)
The tunnel works but in order to reach the webserver I need to SNAT all traffic from my point but I cant seem to get it happen. I have the following rule (all are defined networks):
Source address: My 10.1.1.x host
Dest address: The webserver
Service: Any (also tried HTTP)
Change source to: 192.168.48.X (an IP I've been given to use)
Change Dest: No Change
The address reaching the other firewall is still my 10. address so apparently I haven't gotten this right [:)]
Any help/pointers would be greatly appreciated
TIA
//ACD
This thread was automatically locked due to age.
