This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Routing Problem with two DSL-Interfaces

Hello,
I have following problem.
I have two dsl-wan and would want with pleasure the POP3 and SMTP Traffic about the WAN2 routen.
All other should run through WAN1.

eth0 = LAN 192,168.1.0
eth1 = WAN2 pppoe
eth2 = DMZ 192,168.2.0
eth4 = WAN1 pppoe
Astaro 7.009
What I must exactly configure?
Please, perhaps short Docu?

Thank you
nikfe

This thread was automatically locked due to age.

Parents

0 ClausP over 18 years ago

Astaro Knowledgebase #236926 -> http://portal.knowledgebase.net/article.asp?article=236926&p=5956
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 ClausP over 18 years ago

Astaro Knowledgebase #236926 -> http://portal.knowledgebase.net/article.asp?article=236926&p=5956
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 nikfe over 18 years ago in reply to ClausP

But in this case (Astaro Knowledgebase #236926) becomes the whole net DMZ over WAN2 geroutet.
Would I not need for this dnat or snat and no Masquerading?

nikfe
Cancel
Vote Up 0 Vote Down

Cancel
0 RFCat_vk_01 over 18 years ago in reply to nikfe

nikfe,
you will need to create routing rules for the non default gateway traffic. A MASQ rule should work.
Though you can't do it with 2 pppoe links, ASGs only support 1 pppoe. You would need to bring the 2nd link in as an ethernet interface from a modem/router.

Do you have your own e-mail server?

Ian M
Cancel
Vote Up 0 Vote Down

Cancel
0 ClausP over 18 years ago in reply to RFCat_vk_01

...., ASGs only support 1 pppoe. You would need to bring the 2nd link in as an ethernet interface from a modem/router....

Sorry, this is wrong. Since V7 ASG supports more then 1 pppoe interface..
Cancel
Vote Up 0 Vote Down

Cancel
0 RFCat_vk_01 over 18 years ago in reply to ClausP

ClausP,
perhaps you would care to elaborate, because the manual certainly doesn't.

Ian M
Cancel
Vote Up 0 Vote Down

Cancel