This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Webserver

I have an internal web server running at 192.168.0.100 it's not on an DMZ. Since my ISP blocks HTTP port 80. I want to setup a route from the outside ip "68.x.x.x:1234" and route it to 192.168.0.100:80. Can some one please give me an idea of how to do it. I've tried to setup nat's and packet filters but nothing seemed to work. Any help would be wonderful. Running Astaro 7.006

Thanks

This thread was automatically locked due to age.

Parents

0 BarryG over 18 years ago

You'll need to first create a definition for 192.168.0.100 if you haven't already.

You need a DNAT rule for your EXT Interface, port 1234, change DEST to 192.168.0.100 port 80.

Then, you need a PacketFilter rule to allow traffic from ANY to your server at 192.168.0.100, port 80

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 fearmonge over 18 years ago in reply to BarryG

Ok here is what I did and it's still not working so something is wrong maybe you can tell me what it is.

Dnat
Traffic Source: any
Traffic Service: 1234
Traffic Destination: Wan Card
Nat Mode: Dnat
Destination: 192.168.0.100
Destination Service: http Port 80

Packet rule
Source: Wan Card
Service: 1234
Destination: 192.168.0.100
Allow

Thanks
Cancel
Vote Up 0 Vote Down

Cancel
0 SilverOne over 18 years ago in reply to fearmonge

Fearmonge,

Traffic destination should be WAN Address
Rule;
Source = ANY
Cancel
Vote Up 0 Vote Down

Cancel
0 ReD-MaN over 18 years ago in reply to fearmonge

You packet rule should look like this:

Source: Any
Service: http
Destination: 192.168.0.100
Allow
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 ReD-MaN over 18 years ago in reply to fearmonge

You packet rule should look like this:

Source: Any
Service: http
Destination: 192.168.0.100
Allow
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data