This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

2 Distinct PPPOE connection Interface problem

Hi,
I have 2 different lines on 2 different Interfaces from same service provider with differen static IP's set by remote.

Example:
ETH1 = XXX.XXX.88.45; (set by remote)
GATEWAY = XXX.XXX.88.1; (set by remote)

ETH2 = XXX.XXX.89.23; (set by remote)
GATEWAY = NONE;

Altough I can route anything from ETH1 correctly, ETH2 does not connect to the internet altough interface and line is up.

So I think this is a gateway related problem - because Astaro does not permit 2 different gateways on the same machine.
Any ideas ?

This thread was automatically locked due to age.

0 RFCat_vk_01 over 18 years ago

Under v6.x you need to setup some static routes.

Under v7 which is currently in beta, my understanding is you will be able to do load balancing between links.

Ian M
Cancel
Vote Up 0 Vote Down

Cancel
0 ghanedan over 18 years ago in reply to RFCat_vk_01

I have tried to do some policy based routing to my user:

route all HTTP requests from myuser to ETH2

routing is successfull but I cannot reach to any sites from the second interface.

Can you give an example to the static route ?
Cancel
Vote Up 0 Vote Down

Cancel
0 RFCat_vk_01 over 18 years ago in reply to ghanedan

Sorry, without putting my v6.303 disk back into service I can't show examples, other than to refer you to the user manual.

Ian M
Cancel
Vote Up 0 Vote Down

Cancel