This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Allowing Http to port 80

Anyone know how I can get ASG to allow http traffic in on port 80 to my mac on 192.168.1.110. I have followed the instructions on Astaro's site but to no avail.

1) I have setup my mac as a host (called iMac) in Network Definitions with the IP as above.

2) Setup a Service Definition called Apache TCP Source Port 80 Destination Port 80

3) Packet Filter Rules are Source Any, Service Apache & destination iMac

All lights are on green !

Is there something wrong, or have I missed something ?

Cheers

This thread was automatically locked due to age.

Parents

0 VelvetFog over 19 years ago

You missed something.

You have to set up a NAT forwarding rule to forward the port 80 TCP traffic from your WAN interface to your Macintosh's interface.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 VelvetFog over 19 years ago

You missed something.

You have to set up a NAT forwarding rule to forward the port 80 TCP traffic from your WAN interface to your Macintosh's interface.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data