This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

OWA through Astaro

Hi @ all,

Exchange 2k3, ASL 6.302:

Many IP addresses, one is xxx.xxx.xxx.1 (eth01).

Now, I have created an additional IP on the interface eth01 for OWA, and created a NAT Rule

ANY - OWA_EXTERN (ADDRESS) - HTTPS - Mailserver internal - HTTPS

Also the Rule is Any - https - mailserver, but OWA does not work!

Any ideas?

Thanks!

This thread was automatically locked due to age.

Parents

0 Nekos over 19 years ago

after adding a NAT rule, you need a Packet Filter Rule as well!

Any -> HTTPS -> OWA : Allow

Regards
Neko
Cancel
Vote Up 0 Vote Down

Cancel
0 drgoebel over 19 years ago in reply to Nekos

after adding a NAT rule, you need a Packet Filter Rule as well!

Any -> HTTPS -> OWA : Allow

Regards
Neko

to OWA? To the mailserver?
or the external owa address?
Cancel
Vote Up 0 Vote Down

Cancel
0 BrucekConvergent over 19 years ago in reply to drgoebel

The packet filter rules are applied AFTER the NAT.. so, it would be ANY -> HTTPS -> INternal Mailserver IP.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BrucekConvergent over 19 years ago in reply to drgoebel

The packet filter rules are applied AFTER the NAT.. so, it would be ANY -> HTTPS -> INternal Mailserver IP.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data