Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 2 subscribers
  • Views 1952 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

STP support in Astaro?

Nizzmo
Hello,

does anyone know a answer to my following question:
Supports the Astaro 6.2 Software STP (Spanning tree Protocol) and how can I configure it?

Markus


This thread was automatically locked due to age.
  • 0
    Astaro is not an highspeed router, and therefore dose not support any of the higher/dynamic routing protocolls. :-)
  • 0 in reply to NimmdirKeks
    Astaro is not an highspeed router, and therefore dose not support any of the higher/dynamic routing protocolls. :-)


    This is bad [:(]

    How can i create a redundant Network in a electronic data processing center? I want to use the Astaro Software in the HA-Option and I want to use two Uplinks. 
    The two uplinks can I create with an uplink failover.
    But how can i solve the Problem with the incomeing Traffic from the Internet - can i have two different gateway addresses (one on port eth0 an one on port eth1)?
  • 0 in reply to Nizzmo
    Normaly in such a configuration you would have an front-end router (with a second fail over router). 

    Or you set the Astaro into bridge mode.