This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Print from DMZ to LAN?

Hi folks
Running latest Astaro with 3 NICs, LAN is 192.16.0.1/24, DMZ is 192.16.2.1/24.
DMZ is configured for wireless access point. If I want a wireless client to print to a printer 'living in the LAN', do I use a static route or a NAT rule?
TIA!

This thread was automatically locked due to age.

Parents

0 RFCat_vk_01 over 19 years ago

Depends
1/. is it a shared printer on a PC?
2/. is it a networked printer with one of the cheaper networking devices eg netgear or linksys for SOHO? These will not route, end of discussion.

How do I know, because I tried and tried and tried. The manuals advise they won't network. So I tried using the Astaro in bridging, still the printers wouldn't co-operate.

I did find away around the issue, but it is messy.

Ian M
Cancel
Vote Up 0 Vote Down

Cancel
0 adder over 19 years ago in reply to RFCat_vk_01

Hi, it's a Laserjet with a Jetdirect card on 192.168.0.10 !
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 adder over 19 years ago in reply to RFCat_vk_01

Hi, it's a Laserjet with a Jetdirect card on 192.168.0.10 !
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 quasar3c279 over 19 years ago in reply to adder

Just add a Paketfileter Rule that allows access from the wireless client to the printer in the LAN.

Mario T.
Cancel
Vote Up 0 Vote Down

Cancel