This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Make a seperate public network using our Astaro

Hello, I have looked around the forums and found entires kind of similiar to this question but not exact. We are running ASL 6.105 with our private networks (LAN and WLAN). I want to open up a public WLAN for our customers using our Cisco 1200's and 1130 APs using a seperate VLAN. The Cisco equipment was a snap to set up for the VLAN (they are done and fine, though disabled for now). However, I am going to run the public WLAN network through ASTARO to block their pron and such and shape their bandwith and QOS usage.

How can I block any communications from that Public WLAN routed through the astaro on it's own NIC eth7 for example, from communicating with our internal netwroks eth0 (wired), eth2 (WLAN private) and eth3 (iLO)? eth1 is public to the internet of course. 

Tried packet filtering rules and didn't really work (source public wlan dest -> any internal -> drop). Think i tried the static route of any from eth7 to public internet eth1.

Any ideas?

Many thanks,
-Phil


This thread was automatically locked due to age.
Parents
  • Turns out it is just a matter of packet filtering. I seperated some groups and rules. Also had to adjust some Content filtering whitelist items as they allowed the public lan to view our internal web site (intranet). This was possible now because we had to move away from the ASL VPN becuase it was slower than other products we had used previously.
Reply
  • Turns out it is just a matter of packet filtering. I seperated some groups and rules. Also had to adjust some Content filtering whitelist items as they allowed the public lan to view our internal web site (intranet). This was possible now because we had to move away from the ASL VPN becuase it was slower than other products we had used previously.
Children
No Data