Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 2 subscribers
  • Views 1004 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem with DMZ configuration on ASG120

stone1961
Hello,

I have a problem with my ASG120. I have installed the eth1 for DSL and the eth0 for internal network. The clients in the internal network can work in the internet. Yesterday I installed the eth1 interface for the DMZ. After the installation there were no access from any client to the internet. I couldn´t contact the appliance too. Finally I have to set up the ASG120 once again. In a second test I try to configure the appliance with another IP-Adresses, because I think the problem was a IP conflict. The result was the same and I have to reinstall the appliance once more.
Has everyone an idea for this problem?

Thank you!
Matthias


This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to stone1961
    I would try something like 172.163.1.1 / 255.255.255.0 for eth2.  

    Sounds like you defined the same subnet for external and DMZ while in Router mode... when you do that Astaro shuts down and the only solutions I know is to factory reset it.  In Routed mode you must make sure all your subnets (and those on your VPNs do not overlap). 

    You could try the Bridged mode if you want your DMZ part of the External or Internal subnet but have not tried that yet.
  • 0 in reply to AdrienBelcourt
    Hello,

    thank you so much. I have reconfigured the ASTARO and the problem is solved now.

    I wish you a nice weekend!

    regards
    Matthias