This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Policy based routing confusion

Hi,

is there any info available on how to setup policy based routing ? I've tried to set it up. but it looks like outgoing traffic is always sent out to the interface with the default gateway. I want to route specific traffic over it's dedicated interface (and DSL line) but I can't seem to get it to work. My ISP has changed the DNS so incoming traffic for these URL's is coming in on the correct interface, however, as far as I can see, outgoing traffic is always sent trhough the interface with the default gateway.
Also what I would like to know is, how to configure masquerading in combination with policy based routing.

Franc.

This thread was automatically locked due to age.

Parents

0 Alberto_Interman over 20 years ago

Please access http://www.astaro.com/kb/
there was a typo in my answer
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Alberto_Interman over 20 years ago

Please access http://www.astaro.com/kb/
there was a typo in my answer
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Franc over 20 years ago in reply to Alberto_Interman

Hi,

found that already, but I cannot get it to work. I want to route the SMTP traffic from the SMTP proxy over a separate DSL line, so I've configured the following policy route:

Source interface = Any
Source = Any
Service = SMTP
Destination = Any
Target = DSL Router IP Address

But this doesn't work. SMTP traffic according to accounting is still routed over the interface with the default gateway.

What am I doing wrong here ?

Franc
Cancel
Vote Up 0 Vote Down

Cancel
0 omega over 20 years ago in reply to Franc

Please take a look at:

http://www.astaro.org/showflat.php?Cat=&Board=HTTP&Number=60293
Cancel
Vote Up 0 Vote Down

Cancel