This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ssh sentinel 1.3 and astaro cannot access internal

jason2005 over 20 years ago

I cannot access the internal network but i can ping the computers on the network?
what is it that needs to be done to get to the network?
i have packet rules and NAT maQ setup?

Route print

Active Routes:
Network Destination        Netmask          Gateway       Interface  Metric
          0.0.0.0          0.0.0.0      24.195.96.1  24.195.102.237       20
      24.195.96.0    255.255.240.0   24.195.102.237  24.195.102.237       20
   24.195.102.237  255.255.255.255        127.0.0.1       127.0.0.1       20
   24.195.104.248  255.255.255.255      24.195.96.1  24.195.102.237       1
   24.255.255.255  255.255.255.255   24.195.102.237  24.195.102.237       20
        127.0.0.0        255.0.0.0        127.0.0.1       127.0.0.1       1
      192.168.1.0    255.255.255.0    192.168.57.10   192.168.57.10       1
     192.168.57.0    255.255.255.0    192.168.57.10   192.168.57.10       20
    192.168.57.10  255.255.255.255        127.0.0.1       127.0.0.1       20
   192.168.57.255  255.255.255.255    192.168.57.10   192.168.57.10       20
        224.0.0.0        240.0.0.0   24.195.102.237  24.195.102.237       20
        224.0.0.0        240.0.0.0    192.168.57.10   192.168.57.10       20
  255.255.255.255  255.255.255.255   24.195.102.237  24.195.102.237       1
  255.255.255.255  255.255.255.255    192.168.57.10   192.168.57.10       1
Default Gateway:       24.195.96.1

This thread was automatically locked due to age.