Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 2 subscribers
  • Views 2385 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NAT/Masquerading on ADSL

Taipo
I have set it up as listed below:

ADSL connection
Static IP: 203.18.x.x
Router lan IP - 10.0.0.1
External card/nic - 10.0.0.10 (eth1)
Internal card/nic - 192.168.2.1 (eth0)

I guess Im at a bit of an impass concerning using this ADSL router which already has NAT translating packets. The eth1 ip is 10.0.0.10 and the eth0 is 192.168.2.1 
Internal IP ranges are DHCP from 192.168.2.10-255

My question is should I be even looking at the SNAT and masquerading in ASL or more at static routing? or something else :-/


This thread was automatically locked due to age.
Parents Reply
  • 0 in reply to Taipo
    Have you considered puting the router into bridge mode.  this is how i normally setup all dsl installs I do.  The router will get an ip from from your isp and then assign forward all packets to your ASL box.  This cuts out a lot of confusion with the double NAT.
Children
No Data