This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASL 4.0 between ISDN router.... and LAN

I tried to use ASL 4.0 like this: LAN ( 192.168.1.0/24)----->ASL-etho(192.168.1.1/24)----->eth1 (10.0.0.2/24)--->ISDNRouter(10.0.0.1/24)------> internet VIA ISDN. If i put the router allone( with IP of LAN ) works fine. WITH ASL not even the eth1 is getting status "UP". What additional routing information ist to be set, that the ASL works like "uplink FW" ?? thanks a lot for answering... merry X-mass...

This thread was automatically locked due to age.

Parents

0 Xeno over 21 years ago

On ASL the default gateway have to be the isdn-router.
On all clients the default gateway have to be the ASL.
The isdn-router have to have masquerading enabled.

In case of emergency. Use a packetsniffer to find out more.
tcpdump for ASL

Xeno
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Xeno over 21 years ago

On ASL the default gateway have to be the isdn-router.
On all clients the default gateway have to be the ASL.
The isdn-router have to have masquerading enabled.

In case of emergency. Use a packetsniffer to find out more.
tcpdump for ASL

Xeno
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data