This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Routing Issue HOW-TO

Hi.

I am just new on ASL and I would like to know how can I get a conexion with Telnet port. My local lan es 13x.x.x.x and the computers are ponting to a Router 13y.x.x.x (gateway) to get a conexion with a Unix server. how can I route traffic accross Astaro to point to Unix server.

Thanks for your help.

This thread was automatically locked due to age.

0 uncue75 over 21 years ago

You have to allow incoming port 23 on your external interface.

once that is done you will need to setup a DNAT rule to change the destiation address from the external interface to the unix server's internal interface.
Cancel
Vote Up 0 Vote Down

Cancel
0 muffin over 21 years ago in reply to uncue75

How do you allow a incoming port on your external interface??
Cancel
Vote Up 0 Vote Down

Cancel
0 cyclops over 21 years ago

Raffles,

a DNAT howto can be found @ docs.astaro.org/guidebooks.

Greetings
cyclops
Cancel
Vote Up 0 Vote Down

Cancel
0 firebear_01 over 21 years ago

Hi,
if your IP is real in your message (13x.x.x.x) you must not have a DNAT-rule because your IP would get routed in the Internet. So a rule like :

any -> ssh -> myUnixserver(13y.x.x.x) -> allow

will be enough.

firebear
Cancel
Vote Up 0 Vote Down

Cancel