Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 2 subscribers
  • Views 441 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

single IP firewall

Khosrof
I am in the process of setting up ASL for a corporate firewall.  I would like to know if it is possible to setup ASL as a Single IP Firewall.  What I mean by that is as follows:

We have 32 IPs, subnet mask is 255.255.255.224.  I do not want to separate them into multple subnets, but instead I want to setup the firewall system to act as the gateway between the network and the Cisco router provided by our T1 provider.  This involves setting both NICs to the same IP address and modifying the routing table.  Is this possible with ASL 4?

Thanks in advance,
Khosrof  


This thread was automatically locked due to age.
  • 0
    Hi Khosrof,
    I assume you need a bridging Firewall.
    I haven't found any hints about this at the Astaro.

    You could change at your internal network to a private network (RFC..., like 192.168.x.x) and use the NAT Function from the Firewall.

    HTH

    Regards

    Udo