This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Additional Networks don't appear

When I create additional networks or hosts, these networks don't appear in any other menu (i.e. Filter rules), because the Web GUI makes no changes to the /etc/wfe/conf/netdata.
When doing the changes manually, everything works fine.
I have installed 4.009 and restored my 3.2 configuration file.
Is anything known about that behaviour?

Worgi

This thread was automatically locked due to age.

0 Chris Lynch over 22 years ago

Are you attempting to do this from the command line, instead of the web interface? If you are, have you tried restarting the HTTP deamon?
Cancel
Vote Up 0 Vote Down

Cancel
0 Worgi over 22 years ago in reply to Chris Lynch

No, I do the changes with the web GUI, but I verified it in the netdata.
Cancel
Vote Up 0 Vote Down

Cancel
0 andreas over 22 years ago in reply to Worgi

Hi,

Can you check the file permissions for netdata, please?
Thx,
andreas
Cancel
Vote Up 0 Vote Down

Cancel
0 Worgi over 22 years ago in reply to andreas

Hi Andreas,
its:
-rw-r--r-- 1 root root 1303 Jul 9 20:24 /etc/wfe/conf/netdata

Regards,
Worgi
Cancel
Vote Up 0 Vote Down

Cancel
0 oliver.desch over 22 years ago in reply to Worgi

uuuppppss - should be
-rw-r--r-- 1 wwwrun nogroup 845 Jul 7 18:59 /etc/wfe/conf/netdata

Did you install it from CD 4.008 or was it updated?

read you
o|iver
Cancel
Vote Up 0 Vote Down

Cancel
0 Worgi over 22 years ago in reply to oliver.desch

Hi Andreas, hi Oliver,

that solves my problem.
I installed from the 4.008 image, but I'm using a script to update my vpn tunnels. That script faultly sets the rights on the file. This setting is new in version 4, isn't it?
Thank you very much for the hint.

Worgi
Cancel
Vote Up 0 Vote Down

Cancel