Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 2 subscribers
  • Views 107445 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Emule LowID Problem ( NAT Question )

smay
hi all,

i read this thread here: https://community.sophos.com/products/unified-threat-management/astaroorg/f/58/t/51692

but I have problems to make the same at home

my network:

my pc: 192.168.0.246
astaro: 192.168.0.100

So my PC ha emule installed and i want to connect with this pc. I can - but i always get a low id, someone please can give me a step to step tutorial, the thread above is a little to complex for me  [:$] 


This thread was automatically locked due to age.
  • 0
    This setup works for me:

    Set up an entry under Definitions -> Network 

    Name: My PC,   IP ADRESS: 192.168.0.246  Subnetmask: 255.255.255.255

    Setup two entries in Definitions ->  Services

    Name: eMule - TCP,    Protocol - TCP,   S-Port/Client 1024:65535, D-Port/Server 4662
    Name: eMule - UDP,    Protocol - UDP,  S-Port/Client 1024:65535, D-Port/Server 4672


    In your Packet Filter rules set up two new rules:

    From: Any  To: My PC, Service eMule - TCP, Action: Allow
    From: Any  To: My PC, Service eMule - UDP, Action: Allow  

    Under Network/Masquerading make these two entries:

    Rule Type: DNAT/SNAT Source Address: Any Dest. Address: Your Public Interface_eth? Service: e-Mule - TCP Change Dest: My PC
    Rule Type: DNAT/SNAT Source Address: Any  Dest. Address: Your Public Interface_eth? Service: e-Mule - UDP Change Dest: My PC
  • 0 in reply to ezekiel
    luv ya   thx 4 help !!!!

       
  • 0 in reply to smay
    are you also using socks in emule. i dont get it working dont know what im doing wrong.