This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Need Help Fast! PLEASE!!!

I have a problem where my 2 networks only talk in one direction.

e0 10.1.x.x 255.x.x.x no gw
e1 194.x.x.243 255.x.x.x gw 194.x.x.243

route 10.1_interface to 194_interface
route USA-LAN to 10.X.X.41 (a VPN DEVICE TO USA)

The UK can see all of the USA LAN
but the USA LAN cannot see anything on UK SIDE.

Can anyone help?

This thread was automatically locked due to age.

Parents

0 Pedro_01 over 22 years ago

Hello Alex...

Are you sure, that the external (?) IP of your astaro is the default gateway ???
gw 194.x.x.243

Otherwise... ...please give a little more detailed description like masks, IPs, interface names and definitions (official IPs faked, please).

Ciao,
Pedro
Cancel
Vote Up 0 Vote Down

Cancel
0 alexmigl over 22 years ago in reply to Pedro_01

I'm sorry. Typo the gateways is 246 not 243
Cancel
Vote Up 0 Vote Down

Cancel
0 Marcel_01 over 22 years ago in reply to alexmigl

ok.. not regarding default gateways - if a lan segment can see another lan segment (without using masq/nat) your routing should be ok.. so please check packetfilter on every single point the traffic is going through (things like 'filterlivelog' in ASL should help a lot)

cheers
/marcel
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Marcel_01 over 22 years ago in reply to alexmigl

ok.. not regarding default gateways - if a lan segment can see another lan segment (without using masq/nat) your routing should be ok.. so please check packetfilter on every single point the traffic is going through (things like 'filterlivelog' in ASL should help a lot)

cheers
/marcel
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data