This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem with 3COM NIC and ASL4

I have a "3Com Corporation3c905C-TX/TX-M [Tornado] " as eth2. It seems to work OK but if you look at the network reporting graphs it only shows about 5-10% of the actual traffic going through it. Has anybody experienced anything like this?

Please help.

This thread was automatically locked due to age.

Parents

0 karabela over 22 years ago

i have also a 3c905c-txm as eth0 and eth1 and it works fine.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 karabela over 22 years ago

i have also a 3c905c-txm as eth0 and eth1 and it works fine.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 BQ_03 over 22 years ago in reply to karabela

I have the 3Com Corporation3c905C-TX/TX-M [Tornado] as external and the graphs does not show correctly
The 3Com Corporation3c905B 100BaseTX [Cyclone] as the DMZ show proper graphs tho
Cancel
Vote Up 0 Vote Down

Cancel
0 Hesse over 22 years ago in reply to BQ_03

In the hardware compatibility list there are several 3C90x cards listed including the cyclone but NOT the tornado. Are they really that different. Will Astaro come out with a driver for the tornado? It seems this might be a driver issue.

Any thoughts?
Cancel
Vote Up 0 Vote Down

Cancel
0 Hesse over 22 years ago in reply to Hesse

Bump :-)
Cancel
Vote Up 0 Vote Down

Cancel