This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Changing Internal interface of router

I've had to change the internal interface of the ASL machine. Now I cannot access the ASL machine via https I cannot even ping the machine. I've also changed the admin host's IP address as well to reflect he change. Is there an easy way to fix this?
Thanks!

This thread was automatically locked due to age.

Parents

0 Andy_01 over 22 years ago

if you have access to the command line you can fix your changes in /etc/wfe/conf/itf.conf
Cancel
Vote Up 0 Vote Down

Cancel
0 Sgt_B over 22 years ago in reply to Andy_01

I knew it would be hiding somewhere! Thanks for the tip!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Sgt_B over 22 years ago in reply to Andy_01

I knew it would be hiding somewhere! Thanks for the tip!
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Ian Collins over 22 years ago in reply to Sgt_B

Is it possible to change the ip address range that is used for the internal network? I used to have a range of valid addresses from UUNet which we used on the internal network whilst we had a connection from a new supplier installed (I know I should have connected it to an additional external network). Now that the UUNet connection has gone I would like to change the internal addresses to a private network range like 172.16.2.0. Can I do this without causing myself a whole load of grief, or wil it be better to install ASL again?

Thanks
Cancel
Vote Up 0 Vote Down

Cancel