I've had this problem on 5 out of the 10 or so Astaro Boxes I have installed. It's about to drive me nuts and I can't figure it out for the life of me.
I install the software and configure it. Everything is totally normal until I click on "DHCP" and enable it then the whole thing locks up, it just trys to open the WebAdmin page for 3 - 5 minutes and then FINALLY opens. If I try to make any changes in it takes another 3 - 5 minutes. I also get these
On two of the boxes it gives a internal Server Error and I have to reboot the box to access webadmin again. This is a *MAJOR* problem for us at 2 of our clients any suggestions?!
Error e-mails every time I click on DHCP.
Too much memory for a single process:
250464 kb for /usr/local/httpd/htdocs/index.fpl
wwwrun 1365 3.3 78.1 250464 201132 ? S 17:04 0:29 /usr/local/httpd/htdocs/index.fpl
Last WebAdmin login: admin at Mon from 10.0.0.55
System Uptime : 0 days 0 hours 26 minutes
System Load : 0.16
System Version : Astaro Security Linux 4.000
License : Office Version
Active IP Count : 6 protected IPs
Please refer to the manual for detailed instructions.
I don't have this problem on any other service and it's now happening with 3.XX and 4.00 on these same computers. DHCP does work once you get past the 20 minute config process.
Thanks for the help all!
Benjamin Van Hoesen
This thread was automatically locked due to age.
