This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to masq 2 Subnets on on physical interface

Hi folks,

following config here :

ASL 4.0 2 interfaces

eth0 internal network 192.168.0.250 255.255.255.0
eth1 external TDSL auto assigned.

I set up MASQ for eth0 to be masqued as eth1, works fine. All clients in the internal network can access the internet.

Now i added another subnet (192.168.1.0/255.255.255.0)to the internal network. Its routed through a W2K Pro machine. The clients on the 192.168.1.0 subnet can ping the ASL box, so routing seems to be fine but they cannot access the internet. I added a NETWORK 192.168.1.0 mask 255.255.255.0 in WEBADMIN and also masqued it to eth1. But still no go.

Any ideas? DNS proxy works for 192.168.1.0 subnet.

Andre

This thread was automatically locked due to age.

Parents

0 JimmyM over 22 years ago

Did you create a packet filter rule to allow traffic from the new subnet to the internet?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 JimmyM over 22 years ago

Did you create a packet filter rule to allow traffic from the new subnet to the internet?
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Andre Bienkowski over 22 years ago in reply to JimmyM

Yes, I did. But i found out, that i defined the wrong default gateway on the clients. Now it works, thanks for your answer.

Andre
Cancel
Vote Up 0 Vote Down

Cancel