This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

howto setup routing ?

hi @all,

i´am wondering about routing so maybe somone can get
me out of my personal hell ;-)
ok

eth0 192.168.0.xxx
eth1 192.168.100.xxx
eth2 195.xxx.xxx.xxx dsl dynamic ip

so the system sets the most routes automatic...
but i don´t have any idea setting up a default gateway for eth0 or
eth1.

so can anybody tell me what i have to do ?

This thread was automatically locked due to age.

0 oliver.desch over 22 years ago

Toto,

you don't need a default gateway at the internal
and/or the DMZ interface. Set your external PPPoE
interfacce to 'assigned by remote'.

read you
o|iver

[size="1"][ 30 December 2002, 11:48: Message edited by: oliver.desch ][/size]
Cancel
Vote Up 0 Vote Down

Cancel
0 Igor Kerstges over 22 years ago in reply to oliver.desch

As Oliver says: you don't need to use a gateway for internal network and DMZ, but therefor you need to enter "none" in the gateway-entryfield....

Have fun.
Cancel
Vote Up 0 Vote Down

Cancel