This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

External interface behaving as a JoJo

Hi all experts,

I have a problem with getting my ASL 3.2 up n' running.

I have installed the software, connected the cables to the right switches and so on but still can't get it working.

When I open the kernel live log under log files in the ASL admin web I get the following info:

Dec 6 12:13:34 host kernel: e100: eth1 NIC Link is Down
Dec 6 12:13:36 host kernel: e100: eth1 NIC Link is up 100 Mbps Half duplex

These two lines is constantly repeating. I assume this is a serious problem and why nothing seem to work.

I have tried using other NIC's with the same result. I have even tried other machines with the same result.

Anyone with any ideas? I'm getting desperate...

Regards,
Hampus


This thread was automatically locked due to age.
Parents
  • Hi Hampus Nestenborg

    please don't cross post!!

    I had the same issue here in switzerland. it was because my provider don't like static IP-Address settings on the external interface of my asl-firewall. even if it's allways the same ip-address. so i changed from static to DHCP address assignement and since then I have no problem anymore.

    Another reason could be that you try to connect trough PPPoE but you don't need it. In this case try to use eth1 as "standard ethernet interface".

    hope this helps you

    greetings
    eldorado
  • I'll keep that in mind the next time I'm posting.

    We are using static ip-addresses so that is unfortunately not the issue.

    We have configured ASL to use standarad ethernet interface, so that is already done.

    Thanks for trying anyway :-)

    BR,
    Hampus
Reply Children