This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Port forwarding

As a new ASL user I'm in the process of setting up a firewall using the web admin interface (stating the obvious here :-)). Under the Packet Filter section I had hoped to see a possibility to set up port forwarding. Am I looking in the wrong place or is this feature not implemented?

Thanks.

Ragnar Wisløff

This thread was automatically locked due to age.

Parents

0 eldorado over 22 years ago

Ragnar Wisløff

you find that stuff under Network->NAT/Masquerading.

I hope it's there, I'm not at home and cant have a look.

greetings
eldorado
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 eldorado over 22 years ago

Ragnar Wisløff

you find that stuff under Network->NAT/Masquerading.

I hope it's there, I'm not at home and cant have a look.

greetings
eldorado
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Ragnar Wisløff over 22 years ago in reply to eldorado

Indeed, there's the SNAT/DNAT stuff. Thanks.

Ragnar
Cancel
Vote Up 0 Vote Down

Cancel
0 JimmyM over 22 years ago in reply to Ragnar Wisløff

The "standard" port forwarding (forwarding requests on your external IP in one port is forwarded to a specific internal machine) is done with DNAT. You change the destination from your external IP to the IP of your internal machine.

Other than that, the new manual is pretty good for basic stuff.
Cancel
Vote Up 0 Vote Down

Cancel