This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NMAP return traffic...

Trying to figure out how I can get return traffic from NMAP to make it back into my network through Astaro.

I have tried turning off my portscan detection and also keeping it on and allowing the network that it is coming from. Neither method worked.

I would appreciate any ideas.

Thank you,

This thread was automatically locked due to age.

Parents

0 ollion over 23 years ago

danielrm26,

i am not really sure that i got you right.
You want to scan from inside to outside?
If yes exclude the internal network from
portscan detection and use masquerading to
translate your internal addresses to the firewall ip.
Don't forget the packet filter to allow the scan.

regards
ollion
Cancel
Vote Up 0 Vote Down

Cancel
0 danielrm26 over 23 years ago in reply to ollion

Thanks...have done that stuff but will go through the steps again.

Thanks for replying...

[:)]
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 danielrm26 over 23 years ago in reply to ollion

Thanks...have done that stuff but will go through the steps again.

Thanks for replying...

[:)]
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data