Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 2 subscribers
  • Views 878 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cisco 675 ADSL Router and Astaro Firewall

meldog
Ok I was just curious how I would go about setting up my Astaro firewall with a BRIDGED ADSL connection. Currently I have 2 IP's bridged to my Cisco675 that connects to my hub. Obviously the astaro will be inplace behind the Cisco675, but how would I go about setting up the interfaces? I assume I could use one of the statics with a subnet of 255.255.255.252 on the WAN interface. And then I would have to use Internal IPs on the LAN, correct? 

Matt


This thread was automatically locked due to age.
  • 0
    matt,

    assign one address to Astaro and the other one
    to the crossover connected Cisco.

    It is always a good idea to use private addresses
    in the LAN.

    regards
    ollion
  • 0 in reply to ollion
    Ollion,

    First of all thank you for your response, but one thing is still kinda shady' -- In a bridged connection the IP's are just being pushed throught the cisco. The cisco675 has no setting other than being in bridge mode. When in that mode it cannot be assigned an IP. 

    I guess I will just have to play with this whole mess and see if I can get it to work. I was just curious to know if any one had any success with this>

    Thanks again
    Matt
Unfiltered HTML