This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DNAT question

Hi there

I find myself adding a DNAT for *every* service that I create. Is there a way to DNAT ALL tcp and udp traffic from one ip to another? (without creating a group of services)

Thanks

Emma ^..^

This thread was automatically locked due to age.

0 Gert Hansen over 23 years ago

Hi Emma,

this is no problem.

Just add a Service tcp_udp_all tcp-udp 0:65535 0:65535.

Now use this service in the DNAT as PRE and POST Service and you are set.

Hope that helps

kind regards

Gert
Cancel
Vote Up 0 Vote Down

Cancel
0 Emma_01 over 23 years ago in reply to Gert Hansen

ok, having problems with DNS again

I added a new service:

tcp_upd_all tcp+udp s port 0:65535 d port 0:65535

and I removed all other nats but then nothing gets through?

are you sure this is supposed to work [:)]

Emma ^..^
Cancel
Vote Up 0 Vote Down

Cancel
0 comeanddance over 23 years ago in reply to Emma_01

How about check your packet filter rules.
Cancel
Vote Up 0 Vote Down

Cancel
0 Emma_01 over 23 years ago in reply to comeanddance

any-any-any !!!

but thanks for the advice

Emma ^..^
Cancel
Vote Up 0 Vote Down

Cancel