This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RED Tunnel for UTM 2 UTM, where should i set QOS? On the RED int's or ext int?

I have a RED UTM 2 UTM tunnel and i need to use QOS, but with IPSEC or SSL tunnels i would set QOS on the ext interface. Where do i set this with RED? I need it to give priority for RDP traffic or VPN traffic itself. If I set it on the RED interface will it also work against the EXT interface? i.e will i get priority across the whole lot?

Thanks

This thread was automatically locked due to age.

Parents

BAlfson over 9 years ago

John, I think no one's answered because your question is too general. RDP from where to where? "VPN traffic" - do you mean the RED tunnel or ??? What problem are you seeing that you want to prevent?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel
JohnKenny over 9 years ago in reply to BAlfson

Ok I want to prioritise RDP traffic on a RED tunnel over all uploads from the UTM. We only have 1meg out of UTM so need to give RDP priority as at the moment its to slow to use.

Thanks
Cancel
Vote Up 0 Vote Down

Cancel

Reply

JohnKenny over 9 years ago in reply to BAlfson

Ok I want to prioritise RDP traffic on a RED tunnel over all uploads from the UTM. We only have 1meg out of UTM so need to give RDP priority as at the moment its to slow to use.

Thanks
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data