How to connect two /24 networks

Hi inzane,

You will need to configure another interface (or create a vlan) depending on your UTM configuration.

Hi, Thanks for the reply. 

I think I need to configure another Interface, but how to ?

Cant figure out how to set this properly. 

Hi

you have to set up two interfaces e.g.
eth0 -> 10.95.22.0/24 and eth2 -> 192.168.86.0/24 in "Interfaces & Routing" -> "Interfaces"
your eth1 should be your WAN connection.

Now create a Firewall Rule in "Network Protection" -> "Firewall"

Sources: eth1 & eth2
Services: Any
Destination: eth1 & eth2
Action: Allow

Greetings

Thomas

Hi, 

No go. 

Eth1 is my WAN IP

Eth0 is my local network (10.95.22.0)

Eth2 is local network i want to connect to (192.168.86.0)

Tried with an interface routing but no luck there 

Hi,

Did you create the firewall rule?

You don't need routing if all interfaces are on the same UTM.

On the clients in each network set the lokal IP of the UTM as default Gateway

e.g. 10.95.22.1 on the clients in eth0 and

192.168.86.1 on the clients in eth2.

Regards

Thomas

Hi,

Did you create the firewall rule?

You don't need routing if all interfaces are on the same UTM.

On the clients in each network set the lokal IP of the UTM as default Gateway

e.g. 10.95.22.1 on the clients in eth0 and

192.168.86.1 on the clients in eth2.

Regards

Thomas