UPlink Balancing, Multipath Rules, Firewall

In the multipath rules, did you enable the option: "Skip rule on interface error" under Advanced?

In Uplink balancing from both active interfaces, how's the weight configured for both interfaces?

Hello,

Yes, in the multipath rules, we have enabled "Skip rule on Interface error".

Both Interfaces have the same weight of 100. Persistence Timeout 1 hour.

best regards

Uwe

Sounds a little strange that you had to switch the order of the interfaces in order to make it work again. Maybe the interface wasn't really in error or the system couldn't determine it didn't work (how's the monitoring configured? Automatic or did you configure some other server to monitor uplink?).

The reason that after changing order traffic did flow over the 2nd WAN could be because of the checkmark on "skip rule on interface error", however for this to work the system would actually need to find out that the interface is in error, but in that case the rule is skipped and the traffic is sent out over another working interface.

Hallo Uwe,

If you still need help with this, please show pictures of the Edits of the Interfaces and Multipath Rules.

Cheers - Bob

Hello Bob,

we have changed the order of the Interfaces and disabled "skip rule on Interface error". Now it seems to work.

Thank you for reply.

Best regards

uwe

Hello Bob,

we have changed the order of the Interfaces and disabled "skip rule on Interface error". Now it seems to work.

Thank you for reply.

Best regards

uwe