Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

CLI - Display WAN IP

Hello,

I have installed a new VM with Sophos UTM. If i check the CLI i see "All configuration is done with WebAdmin. Go to https://80.x.x.x:4444 in your browser".

Question: Why is here not the LAN IP displayed?

After some Port Scan and try to access with the WAN IP - nothing is working - seem to be good - but i'm little a bit confused about the message.

Thank you for the feedback.

Best regards

 

PrintScreen:



This thread was automatically locked due to age.
Parents
  • Hi,

    tjhe message is very simple, you do not configure the UTM using CLI unless directed by Support. All configuration work is done via the gui.

    Not displayed probably because it has a lower priority NIC, but more than likely you have not connected the LAN interface in the VM eg not active.

    Ian

Reply
  • Hi,

    tjhe message is very simple, you do not configure the UTM using CLI unless directed by Support. All configuration work is done via the gui.

    Not displayed probably because it has a lower priority NIC, but more than likely you have not connected the LAN interface in the VM eg not active.

    Ian

Children
No Data