This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Determining which IP address on my network is causing bandwidth spikes?

On a UTM 625, firmware 9.355.

I have a portal from Comcast that allows me to see bandwidth usage. I saw yesterday that something was causing my bandwidth to spike to its maximum cap for about 10 minutes.

Can the UTM show me what IP address is potentially using all the bandwidth so I can pin point the culprit?

Alex

This thread was automatically locked due to age.

Parents

0 AChu87 over 9 years ago

I know about the flow monitor, but I'm trying to figure out what IP address or addresses that are using the bandwidth. Not the services being used.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 9 years ago in reply to AChu87

If you click on the number in the Clients column, you will be shown a list of clients.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel
0 AChu87 over 9 years ago in reply to BAlfson

So I clicked on a few items on the list, such as google.com and youtube.com. They say "No data available in table". But it does show traffic.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 9 years ago in reply to AChu87

What service was in use? If it was traffic passing via the HTTP Proxy, you should be able to see the details in that log. Reporting updates every five minutes, so you might be able to get reports during and after on the 'Bandwidth Usage' tab.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 9 years ago in reply to AChu87

What service was in use? If it was traffic passing via the HTTP Proxy, you should be able to see the details in that log. Reporting updates every five minutes, so you might be able to get reports during and after on the 'Bandwidth Usage' tab.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data