Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Unable to access webbased admin of devices on internal network

Over the weekend, I setup a new installation of Sophos UTM on a box at my house. Shortly after getting the new UTM up and running, I tried to get into the web based administration of my small Netgear NAS that is on my home network. This had never been an issue when I was using my Cisco ASA5505. But now, with the Sophos it seems to be blocked by something. I am sure it is going to be something easy to fix, once I find out what that something is. 

When I got into my office on Monday, I had to get into the web interface of a Netgear SOHO router/wap that we use only as an access point out in the shop in our warehouse. I had the same issue trying to get into this web interface as I had at my house with the NAS. The only difference is that at the office we use a Sophos SG210 and at home I am using the software on a small mini atx mb with an atom processor. Both are running version 9.310-11 firmware.

So my question is: Where can I add something to the UTM config to allow access to these hardware appliances so I can have access to their embedded https interfaces?

Thank you in advance for any available help the community can provide.

Dan


This thread was automatically locked due to age.
Parents Reply Children
  • In both cases these devices are on the same subnet as the machine I am trying to access them with. I am not trying to access them from the outside. Although, I am able to access the sophos web admin from the outside when I use the SSL VPN to access my home network. But not the web admin of the NAS.

    The NAS on my home network is a small netgear nas. Think of the web interface that you would use to access and administer most SOHO devices. This is what I cannot access. I can ping the NAS and I can map a network drive to the share on the NAS. I just cannot access the web based administration of the device.

    At the office it is the same result when I try to access the web administration of the netgear SOHO router/wap that we have used as an access point for a while now. In the past we had a fortigate that has now been replaced by the SG210/UTM. Since we have gone to the Sophos we have not been able to access the web admin of the netgear.
  • In both cases these devices are on the same subnet as the machine I am trying to access them with. I am not trying to access them from the outside. Although, I am able to access the sophos web admin from the outside when I use the SSL VPN to access my home network. But not the web admin of the NAS.

    The NAS on my home network is a small netgear nas. Think of the web interface that you would use to access and administer most SOHO devices. This is what I cannot access. I can ping the NAS and I can map a network drive to the share on the NAS. I just cannot access the web based administration of the device.

    At the office it is the same result when I try to access the web administration of the netgear SOHO router/wap that we have used as an access point for a while now. In the past we had a fortigate that has now been replaced by the SG210/UTM. Since we have gone to the Sophos we have not been able to access the web admin of the netgear.
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?