This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPv6 only on WAN interface?

I could not find anything obvious out there to answer this but I wanted to begin playing with IPv6 on my WAN interface, but I do not want IPv6 in my internal interface due to double counting licenses. I have a DMZ where I have only a few hosts that would be okay to be double counted, and those would be my test machines. Does anyone know IPv6 support can be enabled per interface by chance?

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 9 years ago

Only assign an IPv6 to the interfaces that you want, if manually assigning.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 9 years ago

Only assign an IPv6 to the interfaces that you want, if manually assigning.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

IPv6 only on WAN interface?

Submitted a Tech Support Case lately from the Support Portal?