Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 2 subscribers
  • Views 622 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

HA physik / vm

NBrinkmann
Hello,

Has anyone installed a HA Cluster with one Node as Software on Physik and the other one as a Virtual Maschine?

Best regards

Nils


This thread was automatically locked due to age.
  • 0
    They are both Software type installs, so it might work.  Make certain that the connections are the same for both of them (eth0 connected to LAN, eth1 connected to WAN, etc.).
    __________________
    ACE v8/SCA v9.3

    ...still have a v5 install disk in a box somewhere.

    http://xkcd.com
    http://www.tedgoff.com/mb
    http://www.projectcartoon.com/cartoon/1
  • 0
    Yes, I did a while ago (with Hyper-V). Went smooth, once i figured out that I had to enable Jumbo Frames on the HA NIC. Also make sure you allow MAC address spoofing for the virtual NICs.

    ----------
    Sophos user, admin and reseller.
    Private Setup:

    • XG: HPE DL20 Gen9 (Core i3-7300, 8GB RAM, 120GB SSD) | XG 18.0 (Home License) with: Web Protection, Site-to-Site-VPN (IPSec, RED-Tunnel), Remote Access (SSL, HTML5)
    • UTM: 2 vCPUs, 2GB RAM, 50GB vHDD, 2 vNICs on vServer (KVM) | UTM 9.7 (Home License) with: Email Protection, Webserver Protection, RED-Tunnel (server)
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?