Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 2 subscribers
  • Views 478 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Additional external IP from different class, single external nic

itport
Dear all,

I have been given a total blank UTM 9 installation, with no (presumable default rules), with one interface defined as External (obviously, it has two net cards) and configured on an IP from "class c1".

Now, I needed additional (external) IPs and I got them from "class c2".

I tried all possible, even static "gateway" route  for the additional IP x but still not being able to ping / connect (on the initial set up ip, all works).

May I get any hint from you?

Thank you!


This thread was automatically locked due to age.
  • 0
    Setup the additional addresses at Interfaces & Routing > Interfaces > Additional Addresses.  If the default rules have been erased as well, you may want to consider doing a factory reset at Management > System Settings > Reset Configuration or Passwords.  Afterwards, on next connection to WebAdmin, the install wizard should start.  This'll create some of the baseline configuration for you.

    Ping connectivity is controlled at Network Protection > Firewall > ICMP.
    __________________
    ACE v8/SCA v9.3

    ...still have a v5 install disk in a box somewhere.

    http://xkcd.com
    http://www.tedgoff.com/mb
    http://www.projectcartoon.com/cartoon/1
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?