This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

UTM Home Network Problem

Hi there,

I have a problem using my UTM Home Firewall after the initial setup.
UTM 9.308-16

My setup:

eth0 = Internal (LAN)
eth1 = External (WAN) Dynamic IP Internet Gateway
NAT Masquerading: Internal --> External (WAN)
Firewall Rule: Source: Internal; Service: Web Surfing (Group); Destination: External

Everything else is deactivated.

I am not able to surf unsless I activate "Web Protection". Why isn't this working without activating "Web Protection"?

Thanks in advance.

This thread was automatically locked due to age.

0 Scott_Klassen over 10 years ago

Firewall Rule: Source: Internal; Service: Web Surfing (Group); Destination: External
Source: Internal (Network); Service: Web Surfing Group; Destination: Internet IPv4.

Try that.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 fl4m1ngh0m3r over 10 years ago in reply to Scott_Klassen

Source: Internal (Network); Service: Web Surfing Group; Destination: Internet IPv4.

Try that.

It seems like it's working.

Thank you [:)]
Cancel
Vote Up 0 Vote Down

Cancel
0 Scott_Klassen over 10 years ago

No problem. Have a good weekend.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

UTM Home Network Problem

Submitted a Tech Support Case lately from the Support Portal?