This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to setup Sophos

Hello,

Right now I have a Sophos UTM Home server running. Tomorrow I will be connected to a fiber network via a Vigor 2132Fvn modem. The ISP has disabled the bridge-modus. So, how do I setup the new modem?
I saw 'True IP DMZ' function on it. Is this useful to setup the UTM?

Best regards,R
Roy

This thread was automatically locked due to age.

0 Scott_Klassen over 10 years ago

I saw 'True IP DMZ' function on it. Is this useful to setup the UTM?
You'd need to research the documentation for the Vigor device to determine this. Otherise, without bridged mode, you would need to run double-NAT.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 darrellr_01 over 10 years ago

Or maybe you do not need to run NAT at all on the UTM. Just use routing internally on the Sophos and the only place you will need to NAT is on the modem/router provided. You will still have a lot of the same limitations (NAT rule on modem/router, firewall rule on Sophos to forward packets in from internet) but you don't really need the extra complications of double-nat.
Cancel
Vote Up 0 Vote Down

Cancel
0 RoyM_old over 10 years ago

Thank you both for your time to write me an answer. This afternoon I wil go and try to connect things. I'll come back to you later this week with results ;-)

Bye
Cancel
Vote Up 0 Vote Down

Cancel
0 Scott_Klassen over 10 years ago

Sounds good Roy.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

How to setup Sophos

Submitted a Tech Support Case lately from the Support Portal?