This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DNS issues

So i am using the UTM as my DNSserver in DHCP and i have it setup to use forwarders to resolve addresses outside of my domain. for anything within my domain corp.mysite.com i have setup a request routing and have it pointed to my two DC's/DNS servers.. if i nslookup query the UTM i get a server failed response.. if i query the DC directly it works fine.. any ideas?

This thread was automatically locked due to age.

0 Scott_Klassen over 10 years ago

First thing that comes to mind: Is the machine you are doing the lookup from in allowed networks at Network Services > DNS > Global?

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 DavisDarvish over 10 years ago in reply to Scott_Klassen

First thing that comes to mind:  Is the machine you are doing the lookup from in allowed networks at Network Services > DNS > Global?

it isnt explicitly but it is implicit in the Internal network definition . i have Internal IPV4/6 (created during setup) as an allowed network.

Internal (Network) 192.168.0.0/16 | 2601:7:16**:****::/64

and my systems IP address is 192.168.1.100 w/ mask 255.255.0.0

the response is an error  like this

*** UnKnown can't find admaster: Server failed

as opposed to a timeout which would happen if it wasnt authorized like the error below

DNS request timed out.
    timeout was 2 seconds.

also using either the host name or the fqdn doesnt change the response of the dns server
Cancel
Vote Up 0 Vote Down

Cancel

DNS issues

Submitted a Tech Support Case lately from the Support Portal?