Guest User!

You are not Sophos Staff.

Thread Info
  • State Verified Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 40 replies
  • Subscribers 9 subscribers
  • Views 71238 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[INFO-152] Network Monitor not running - restarted

SilvanoBiger
Been receiving a few webadmin info-152 e-mails from the UTM
Did a dmesg...

[1123325.232580] nwd[10968]: segfault at 2e323931 ip 000000002e323931 sp 00000000ffd900c0 error 14


Current software version...: 9.310009
Hardware type..............: Software Appliance
Installation image.........: 9.308-16.1
Installation type..........: asg
Installed pattern version..: 78536
Downloaded pattern version.: 78536
Up2Dates applied...........: 2 (see below)
                             sys-9.308-9.309-16.3.1.tgz (Mar 15 19:20)
                             sys-9.309-9.310-3.9.4.tgz (Mar 27 05:29)
Up2Dates available.........: 1
Factory resets.............: 0
Timewarps detected.........: 1

Any ideas?


This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to phuongpham
    To test this further and make it segfault again, just unplug the cable from the WAN port and nwd will segfault again once you plug it back in.
    Same as it does at the initial boot of the UTM.

    Give it some time between tries as it seems to need some time for the error to be reproduced.
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?